Everything Electricity, from your Circuit Panel, Outlets, Switches, Receptacles, Light Fixtures, Cable, Wire..

Controlling Two Bulbs Using Two Single Pole One-Way Switch

Share This Post

Share on facebook
Share on linkedin
Share on twitter
Share on email

Layout diagram

Wiring diagram

Equipment and tools: Steel rule, Plier, Tester, Screw Driver, Combination Plier, Cable Insulation Knife, Awl, Mallet. 

Items 

  • Single pole one-way switch 02 no’s
  • Batten Holder 02 no’s
  • Sunk Box 02 no’s
  • Round Block 02 
  • 1/1.3 Red Wire
  • 1/1.3 Blue Wire
  • Bulbs 02

Procedure: Take the measurements according to the layout diagram and create the wiring diagram. Use the equipment and tools to draw on the board. Then, use 1 ½ clips for three wires and 1 ¼ clips for two wires and set them on the board. After setting the switches and the rest of the components, set the 1/1.3 red wire and 1/1.3 blue wire with the clips on the board. Check whether the circuit is correct through a multi-meter and supply electricity. 

Conclusion: The circuit activated and lit the two bulbs 

Leave a Reply

Your email address will not be published. Required fields are marked *

More To Explore